Product Overview: Permanent Solution for New-Generation Volvo Steering Lock Failure

Compatible Part Numbers:
S90 | V90 | XC90 | XC60 | 31476490 | 32221636 | 32246736

This emulator provides a permanent solution for the Electronic Steering Lock (ELV/ESL) Failure commonly found in Volvo's new-generation SPA and CMA platform vehicles (2020–2022+), including the S90, V90, XC90, XC60, V60, and XC40. This fault can prevent the vehicle from starting or cause the ignition system to become unresponsive.

The authorized Volvo repair procedure typically involves ordering and replacing the steering lock unit, which is expensive and requires complex online programming. This emulator is designed to permanently bypass the failure-prone mechanical steering lock mechanism.

No Programming Required

Unlike some vehicle-specific emulators (such as Mercedes W204 ESL emulators), this unit does not require coding or programming. Once connected, it immediately provides a valid “steering lock operational” signal to the vehicle. In this sense, it is a true Plug-and-Play solution.

Installation Instructions

1. Turn the ignition off.

2. Disconnect the wiring connector from the faulty original ESCL unit.

3. IMPORTANT: If the steering lock is mechanically stuck in the locked position, remove the lock assembly from the vehicle before proceeding.

4. Connect the purchased emulator to the vehicle's original ESCL connector.

5. Connect a professional diagnostic tool to the vehicle.

6. Access the CEM module (or the relevant system) and clear/reset all steering lock-related fault codes.

7. Start the vehicle.

LED Status Indicators

The emulator simulates the operating status of the original steering lock:

Solid Green LED

Meaning: Successful operation. The emulator is in the unlocked state and the vehicle is ready to start.

Solid Red LED

Meaning: The emulator is in the locked state. (This may be normal when the ignition is switched off.)

Flashing Red LED

Meaning: Error condition. The emulator is connected, but the steering lock fault code stored in the vehicle's control module (CEM) has not yet been cleared. Connect a diagnostic tool and reset the fault codes.

Compatible Vehicles

• Volvo S90

• Volvo V90

• Volvo XC90 (2020–2022+) B5

• Volvo S60

• Volvo V60

• Volvo XC60